Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterTrusted Gate Installation for Pearland Homeowners
A new gate in Pearland typically costs between $2,800 and $9,500 installed, depending on the material, width, and whether you’re adding automation. Most standard single driveway gates run $3,200 to $5,400. The price is written and handed to you before anyone touches a tool on your property, and that number will not move when the invoice arrives.
Vance Gate Repair has installed and repaired more than 22,000 gates since 2014, when Adrian Vance moved from commercial access-control work into residential driveway and pedestrian gates. Every installation follows The Haven Standard: a written scope and price before work starts, a photographed record of every step, and the 365-Day Done Right Promise backing the finished job. Call (346) 253-3225 and a live person answers, 24 hours a day, seven days a week. No voicemail loop. No callback queue.
What Our Gate Installation Service Includes
Every Gate Installation - Pearland starts with the same question: what is this gate actually doing for you? Security, privacy, keeping a dog in the yard, keeping solicitors out, or simply defining the property line. The answer changes the design, the hardware, and the price. Here is what we install and what each option involves.
Driveway Gate
A driveway gate spans the vehicle entrance to your property, usually 10 to 16 feet wide for a single opening and up to 30 feet for a double. In Pearland, where lots range from compact Silverlake properties to larger acreage off Bailey Road, we size the gate to the actual opening and the turning radius of whatever you drive: a full-size pickup needs more swing clearance than a sedan. We set the posts in concrete below the frost line, hang the gate level on adjustable hinges, and photograph the finished installation before we leave.
Pedestrian Gate
A pedestrian gate is a smaller, person-width gate, typically 36 to 48 inches wide, installed beside or within a driveway gate. It is the gate you actually use every day: to get the mail, to walk the dog, to greet a neighbor without opening the big gate. In Pearland we often install these on the latch side of a driveway gate, with a self-closing hinge and a keypad or lock that matches the system on the main gate.
Sliding Gate
A sliding gate travels horizontally along a track or a cantilever rail, rather than swinging inward or outward. It is the right choice for Pearland properties where the driveway slopes up toward the house, where a swing gate would push into a drainage swale, or where a wide double gate would eat too much flat space. We install both rolling-track sliders for wide openings and cantilever sliders for low-maintenance operation, and we set the motor and limit switches to match the gate’s exact travel.
Swing Gate
A swing gate pivots on hinges from posts, opening either into or away from the property. It is the most common gate type in Pearland, and the one we install most often, because it needs the least hardware and works on flat or gently graded driveways. The two details that matter most are post depth and hinge weight rating: we set posts in concrete at a depth determined by the gate’s weight and wind load, and we use hinges rated for the full leaf weight, not the bare minimum.
Double Gate
A double gate is two matched leaves that meet at the center, used for driveways 16 to 30 feet wide. In Pearland, double gates are common on larger lots in neighborhoods such as Green Tee and Shadow Creek Ranch, where a single leaf would be too heavy to swing smoothly. We install both leaves so they meet with a consistent gap, align the latch and center stop, and if automation is added, sequence the two opener arms so the closing leaf closes first.
Security Gate
A security gate is built around the frame, not just the appearance. It uses thicker steel posts, a heavier frame, and a locking mechanism rated for sustained force rather than casual entry. In Pearland, homeowners request these for side-yard entrances, back property lines, and any gate that protects expensive equipment or a pool. We include a photographed record of the post depth, the concrete, and the hardware so you have documentation, not a handshake.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service for Gate Installation
We work on what is already on your property, and if you are adding automation to a new gate, we install the brand that fits the job. We have installed and serviced Gate and DoorKing and Linear operators across Pearland for years, and we keep a stock of common OEM parts for repairs that come up later.
Ghost Controls gets specified a lot on residential gates because the hardware is approachable, and we know its limits: where the arm geometry works and where a ram-style Viking operator is the better call. If you already have a Linear or a DoorKing opener on an old gate and want to reuse it on a new one, we will give you an honest read on whether that motor has another gate in it. Whatever brand is on the property, we can install around it or replace it with a written price before work starts.
BeforeAfterSigns You Need Gate Installation Right Now
- The gate is sagging more than two inches at the latch side. A gate that drags on the ground or no longer meets the latch has already passed the point of hinge adjustment. In Pearland humidity, the posts have likely shifted or the frame has twisted, and continuing to force the gate open damages the opener, if one is installed.
- The gate no longer closes fully without help. If you are pushing or pulling the gate the last few inches, the leaf is out of square or an operator arm is failing. A gate that will not close is an invitation, and on a property with kids or a dog, that is an urgent fix. New installation replaces the problem instead of chasing it.
- You are manually opening a gate that was built for automation. If the opener was removed or died and you are swinging a 300-pound gate by hand every day, the effort is damaging the hinges and the post. Installing a properly sized opener on a correctly hung gate ends that.
- The gate is rusted through at the frame corners. Surface rust is cosmetic. Rust that has eaten through the tube means the gate has lost its structural rating and is a few good pushes from a cracked weld. No amount of grinding and repainting restores a rusted-through frame.
- The gate was installed by a general contractor or a fence company. Not every builder who hangs a gate understands gate geometry. If the gate was put in when the house was built and has never opened smoothly, it needs a gate specialist, not another repair. We see this across Pearland: gates hung on fence posts that were never set deep enough for the weight.
Our Gate Installation Process - Step by Step
- 1
Site measurement and written scope. We measure the actual opening at three points: top, bottom, and middle. Pearland lots shift, and the distance is rarely the same at all three. We note the grade, the driveway material, the distance to the power source, and the swing clearance. Then we write the scope and the price. Clause 1 of The Haven Standard: you receive the written price before any work begins.
- 2
Post setting and concrete work. We dig, set, and brace the posts so they are plumb in both planes before the concrete goes in. Post depth depends on the gate weight and the wind load, and for a 600-pound gate, that means deeper than a fence post. We photograph the hole before the pour, the depth with a tape on it, and the finished post. That photo goes into your record.
- 3
Gate hanging and hardware alignment. We hang the gate leaf on adjustable, weight-rated hinges, then level and square it with a magnetic level and a measured gap check at both ends. The latch side gets set so the gate closes with a positive stop, not a bounce. If automation is going on, we set the leaf geometry to match the opener’s stroke, not the other way around.
- 4
Automation, locking, and safety devices. When the job includes a motor or opener, we mount the operator, set the limit switches to the exact travel, and wire in photo-eyes: the infrared beam that stops and reverses the gate if anything crosses the path. We test the entrapment reversal with an actual obstruction, not just the manufacturer’s manual. Then we photograph the settings and note the part numbers.
- 5
Final walkthrough and documentation. Before we leave, you get a written record of everything installed, the make and part number of every component, and the photo log from the whole visit. We show you how the manual release works, how to adjust the auto-close if your system has one, and what to look for in the first month. The job is not done until you have the paperwork in your hand.
How Much Does Gate Installation Cost in Pearland?
A typical single driveway gate in Pearland runs $3,200 to $5,400 installed, including posts, concrete, hinges, and standard hardware. A double driveway gate starts around $5,800 and runs to $9,500 depending on width and material, which you can see in our Gate Installation pricing breakdown. Pedestrian gates are the most affordable: $1,200 to $2,800 for a steel gate, installed and adjusted. Adding an opener to any of those adds $1,400 to $3,200, depending on the brand, the arm type, and the power run distance.
What drives the cost is leaf weight, gate width, post depth, and the automation brand. A 14-foot steel gate on a cast-in-place post costs more than a 10-foot aluminum gate on a post anchor, and that is not markup: it is material and labor. What you should never pay for is a surprise. We write the price before the job starts and that number holds. If you have a written estimate from another Pearland gate company, bring it to us: we will review it at no cost and give you a straight comparison, line by line, under Clause 1 of The Haven Standard.
Gate Installation Near Pearland - Our Service Area
Vance Gate Repair serves Pearland and the surrounding communities, including Friendswood, Alvin, Missouri City, Bellaire, League City, Deer Park, Stafford, Pasadena, West University Place, Jacinto City, and Houston. We schedule installations by appointment based on the scope, not the calendar: you get a written date range and the technician’s name and photo before arrival. For more on what we do in nearby areas, see our Gate Installation in Friendswood and Gate Installation in Alvin pages.
Serving Pearland, TX - Our Local Coverage Area
We’re based in the Pearland area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
Frequently Asked Questions - Gate Installation in Pearland
Gate installation includes the gate leaf or leaves, posts, concrete, hinges, latch or lock hardware, and leveling and adjustment so the gate closes squarely. If automation is part of the job, it also includes the opener, arm, mounting hardware, safety photo-eyes, and the wiring. Every installation from Vance Gate Repair Pearland includes a written price before work starts and a photographed record of the work when it is finished.
Most single gate installations in Pearland are completed in one day, including post setting, hanging, hardware, and adjustment. Double gates and installations that include automation typically take two days because the concrete needs to cure before the operator is mounted and tested. We give you the date range in writing before we start, and the technician’s name and photo before arrival.
A standard single driveway gate runs $3,200 to $5,400 installed; a double gate $5,800 to $9,500; a pedestrian gate $1,200 to $2,800. Adding an opener adds $1,400 to $3,200. The exact figure depends on width, material, post conditions, and brand. Your price is written and handed to you before any work begins, and it does not change when the invoice arrives. Call (346) 253-3225 for a free, written estimate.
Yes. We install and service Linear, Viking, Ghost Controls, DoorKing, and five other major automation brands, including LiftMaster, FAAC, BFT, Elite, and Mighty Mule. If your new gate is going to be automated, we will size the operator to the gate, not sell you whatever is on the truck. If you have an existing opener you want to reuse, we will tell you honestly whether it has another gate in it.
Installation work is measured, ordered, and scheduled, so we do not install gates on a same-day emergency basis. But if your gate is down and you need it secured before the installation date, we can often dispatch a technician to remove or brace the gate so the property is not left open. A live person answers at (346) 253-3225 around the clock, and we will tell you the soonest real installation date, not a promise we cannot keep.
Every installation is covered by the 365-Day Done Right Promise: if the gate is not right within one year, we make it right at no additional charge. The written record of what was installed, including part numbers and photos, stays with you, so a warranty claim does not depend on memory or paperwork you were never given. Your documented proof is the warranty.
Clear the area: move vehicles, trash cans, or anything parked within the swing or slide path, and flag any irrigation lines, invisible pet fences, or landscape lighting near the gate posts. If you have an existing gate, leave it as it is: we will photograph it before removal. That is the preparation. Everything else is on us.
Schedule Your Gate Installation Service in Pearland Today
Call (346) 253-3225 and a live person will pick up, day or night. You will get a written price before any work begins, a free estimate on any installation, and a photographed record of the completed job. If you have another company’s written estimate in hand, bring it to us for a free second opinion. No pressure, no surprise invoice, no waiting on a callback.
Written by Adrian Vance, Owner at Vance Gate Repair, serving Pearland since 2014.